Technical Features; Safety Warnings - Trix 26000 Serie Manual De Instrucciones

Technical Features:

G Suitable operating system:
DC power (max +/– 14 volts DC) or
DCC command control system adhering to the
NMRA standards.
G Working headlights.
G Can be switched to catenary operation.
G Only available with DCC operation:
Controllable sound effect for a horn.
Minimizing of the acceleration and braking delay
that has been set.
G Bridge plug included with the locomotive.
If you are going to run the locomotive only with
DC power, it may be best to unplug the decoder
and replace it with the bridge plug.
G Minimum radius required for operation:
356 mm / 14".
The necessary maintenance that will comes
due with normal operation is described below.
Please see your authorized Trix dealer for repairs
or spare parts.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed
in Trix products or where Trix products have been converted in such
a way that the non-Trix parts or the conversion were causal to the
defects and / or damage arising. The burden of presenting evidence
and the burden of proof thereof, that the installation of non-Trix parts
or the conversion in or of Trix products was not causal to the defects
and / or damage arising, is borne by the person and/or company
responsible for the installation and / or conversion, or by the customer.

Safety Warnings

G This locomotive is to be used only with an operating
system designed for it.
G This locomotive must never be supplied with
power from more than one transformer.
G Pay close attention to the safety warnings in the
instructions for your operating system.
5