Care and cleaning
Important
• Wipe out food oil adhered to plastic parts.
• Some household chemicals may cause damage, so use
• If undiluted detergent is used or soapy water is not
wiped off thoroughly, it may result in cracks of plastic
parts.
Cleaning
• Clean water tank and dispenser tank if they have not
been used for more than 48 hours.
•
and the door. Wash them by warm soapy dishwashing
water. After that, rinse them in clean water and dry.
• Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water thoroughly.
• Wipe the exterior with a soft cloth each time it gets dirty.
• Clean the magnetic door seal with a toothbrush and
warm soapy dishwashing water.
Note
•
paint, polishing powder, benzine, boiled water, etc.)
which may cause damages.
• If you pull out the power plug once, wait 5 minutes at
least before connecting the power plug again.
• The glass shelves weigh approximately 3 kg each. Hold
• Do not drop objects inside the refrigerator or strike the
inner wall. This may cause cracks to inner surface.
• The shaded parts in the picture below are unremovable.
Unremovable
EN-19
Switching off your
refrigerator
period, the following steps should be taken to reduce
1. Remove all food.
2. Remove the power plug from the socket.
3. Clean and dry the interior thoroughly.
4. Keep all the doors open slightly for a few days to dry.
Defrosting of the cooling unit
Defrosting is automatically operated by a unique energy
saving system.
When the compartment light
is blown
Contact the service agent approved by SHARP to
replace the light. The light is not to be replaced other