Revell Control ROTOBOT Manual De Instrucciones página 8

1. gettINg StArteD:
Before switching on, the thrust
controller (left controller on
the remote control) must point
fully downwards (fig. 1). We
recommend switching the turbo
switch to "OFF". Then set the
ON/OFF switch on the remote
fig. 1
control to "ON" (fig. 2). The
power LED starts to flash rapidly.
2. trIMMINg tHe CoNtroLLer:
Correct trimming is crucial for ensuring that the helicopter flies smoothly. It is easy to do, but does require a little patience and a light touch. Please observe the following guidelines precisely:
Move the actuating regulator carefully upwards to make the helicopter move approximately 0.5 to 1 metre upwards.
If the helicopter keeps
turning quickly or
slowly to the right...
If the helicopter turns quickly or slowly to the right by itself, turn the wheel for left/right
trimming counterclockwise until the helicopter no longer turns by itself.
3. FLIgHt CoNtroL (WItH MotIoN CoNtroL):
In order to start or to fly the helicopter higher, push the actuating regulator carefully
forward.
To move forward, carefully push the direction stick forward.
To make left turns, carefully push the direction stick to the left, provided that the tail of
the helicopter is pointing towards the pilot.
8
Flying the Helicopter
fig. 2
Now set the ON/OFF switch on
the helicopter to "ON". Place the
helicopter on the ground so that
the fuselage points in your
direction. As soon as the remote
control has made contact with
the helicopter, all LEDs on the
helicopter illuminate and the
power LED on the remote
control flashes slowly.
If the helicopter keeps
turning quickly or
slowly to the left...
If the helicopter turns quickly or slowly to the left, turn the wheel for left/right trimming
clockwise until the helicopter no longer turns by itself.
In order to land or to fly lower, move the actuating regulator backwards.
Minimal corrections to the regulator are required to allow the helicopter to fly smoothly.
To move backwards, carefully pull the direction stick back.
To make right turns, slowly push the direction stick to the right, provided that the tail
of the helicopter is pointing towards the pilot.
Slide the thrust controller to
full speed and back down to
zero to activate the remote
control; the power LED
illuminates constantly and
the helicopter is ready to
start.