General Operation - Apex Pro-care 2 Manual De Instrucciones

Pro-care 2 / English
4. Operation
NOTE- Always read the operating instruction before use.

4.1 General operation

1. Switch on the main power switch found from the side of the pump.
2. The pump unit is to delivering air into mattress, wait least 30 mins for mattress to be inflated.
NOTE- Every time when mattress is first setup for use, it is recommended that the pressure knob to be
set to "Max" for the quickest inflation. User can then adjust air mattress to the desired soft-
ness afterward.
3. The low pressure indicator (yellow LED) will light up when the mattress is not fully inflated.
4. When the appropriate pressure is reached, the low pressure indicator (yellow LED) will go off and
normal pressure indicator (green LED) will light up automatically.
5. According to the weight and height of the patient, adjust the knob setting to the most comfortable
level without bottoming out, then the pressure in mattress will slowly increase to a certain value af-
ter the air mattress is ready to use.In an event of the power failure situation, the PFA will alarm. User
can disable by pressing the alarm mute button.
1
4
2
5
7
3