Intended Use - Black and Decker FSMH1621 Manual De Instrucciones

Intended use

Your Black & Decker steam mop has been designed for
sanitising and cleaning sealed hardwood, sealed laminate,
linoleum, vinyl, ceramic tile, stone and marble floors and for
refreshing carpets. This appliance is intended for indoor
household use only.
Warning! Read all of the 'Safety, Maintenance,
Service' manual carefully before operating
this appliance.
Read all of this manual carefully before operating
the appliance.
Features
This appliance includes some or all of the following features.
1. ON/Off switch
2. Lock off button
3. Trigger switch
4. Steam nozzle
5. Hand held steam cleaner
6. Autoselect button
TM
7. Filler cap
8. Water tank
9. Steam mop body
10. Handle
11. Steam head
12. Steam head cleaning pad
13. Resting mat
14. Carpet glider
15. Bottom cable tidy hook
16. Top cable tidy hook
17. Cable management clip
18. Jug
Accessories
This appliance includes some of the following accessories
others are available to purchase from the Black & Decker
website.
The performance of your appliance depends on the accessory
used. Black & Decker accessories are engineered to high
quality standards and designed to enhance the performance
of your appliance. By using these accessories you will get the
very best from your appliance.
(Original instructions)
Flexible hose and handle
For convenient use of all accessories.
Variable steam jet nozzle
For higher pressure steam bursts, twist to change
the spray pattern of the steam burst.
Small brush (Blue)
For cleaning bathrooms.
Small brush (Yellow)
For cleaning kitchens.
Small brush (Green)
For cleaning toilets.
Small Squeegee
For cleaning glass doors and windows.
Warning! Do not use the window squeegee on cold
glass. It may cause the glass to break.
Assembly
Warning! Before attempting any of the following operations,
make sure that the appliance is switched off and unplugged
and that the appliance is cold and does not contain any water.
Attaching the handle (Fig. A)
Slide the bottom end of the handle (10) into the top end of
u
the steam mop body (9) until it clicks into place. The arrow
on the handle (10) should be aligned with the top of the
steam mop body (9).
Attaching the steam head (Fig. B)
Slide the bottom end of the steam mop body (9) onto the
u
steam head (11) until it clicks into place.
The steam head can be removed from the Steam mop
u
body by pressing the steam head release button (19) and
pulling the steam mop body (9) off the steam head (11).
ENGLISH
5