Flex AD 14,4 Instrucciones De Funcionamiento Originales página 21

AD/ADH/AID 14.4
ADH 14.4
1–15: Screwing
: Drilling
: Impact drilling
klqb
qÜÉ=ÑêáÅíáçå=ÅäìíÅÜ=áë=ÇÉ~Åíáî~íÉÇ=áå=íÜÉ=Çêáää=
éçëáíáçå= K
Speed preselection (AD/ADH 14.4)
`^rqflk>=
aç=åçí=ÅÜ~åÖÉ=ëéÉÉÇ=ìåíáä=íÜÉ=éçïÉê=íççä=
áë=~í=~=ëí~åÇëíáääK
 Move selector switch to the required setting:
1: Low speed, high torque
2: High speed, low torque
Inserting the tools
`^rqflk>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=éçïÉê=íççäI=
ëÉí=íÜÉ=ÇáêÉÅíáçå=çÑ=êçí~íáçå=ëÉäÉÅíçê=ESF=
íç íÜÉ ãáÇÇäÉ=éçëáíáçåK
Chuck (AD/ADH 14.4)
The chuck securely holds drill bits with
a diameter of 1.5–13 mm, ¼" screwdriver
bits as well as ¼" bit holders.
 Hold the power tool with one hand and
rotate the chuck with the other hand.
– To open the chuck, rotate it counter-
clockwise.
– To close the chuck, rotate it clockwise.
 Insert tools.
 Close the chuck fully.
 Carry out a test run to check that the tool
is clamped in the centre.
Tool holder (AID 14.4 ¼)
klqb
qÜÉ=íççä=ÜçäÇÉê=ëÉÅìêÉäó=ÜçäÇë=ëÅêÉïÇêáîÉê=
Äáíë ~ë=ïÉää=~ë=¼?=Äáí=ÜçäÇÉêëK
 Pull tool lock forwards and press in the tool
all the way.
 Release tool lock.
 To remove the tool, pull tool lock
backwards.
21