HQ-Power VDL100GM Manual De Instrucciones página 2

• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Lamps and fuse
This fixture is fitted with halogen lamps which are highly susceptible to damage if
improperly handled. Never touch the lamps with your bare hands as the oil from
your hands will shorten lamp life. Also never move the fixture unless the lamp had
some time to cool down. Lamps are not covered under warranty conditions.
Caution: Always replace with exact the same lamp and fuse. Replacing with
anything else can damage your unit and will void the warranty.
Warning: If after replacing the lamp or fuse the unit still continues to blow up the
lamps, STOP using the unit and contact your dealer.
This unit is equipped with a built-in safety breaker. This breaker is designed to protect the unit in case of power
trouble. This will reduce the risk of an electric shock and fire. To reset the breaker push the breaker button in until
you hear it pop-back into place.
Lamp replacement:
Never attempt to change the lamp while the fixture is plugged in and running. Always disconnect main power and
allow the unit some time to cool down before replacing the lamp.
Be sure to follow all the proper handling procedures:
1. Never touch the lamp with your bare hands.
2. Remove the two screws located on the front of the unit.
3. Remove and replace the lamp.
4. Reassemble in reverse order.
Remark: Do not operate the device when the cover is open.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The construction to which the device is attached should be able to support 10 times the weight of the device for
one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
VDL100GM 2 VELLEMAN