Manuales relacionados para Hansgrohe AXOR Serie
Resumen de contenidos para Hansgrohe AXOR Serie
- Página 1 EN Installation / User Instructions / Warranty FR Instructions de montage / Mode d'emploi / Garantie ES Instrucciones de montaje / Manejo / Garantía Axor Massaud 18112001 Axor Massaud 18115001...
-
Página 2: Technical Information
English Technical Information Recommended water pressure 15 - 75 psi Max. water pressure 145 psi Recommended hot water temp. 120° - 140° F* Max. hot water temp 176°F* Flow rate 1.1 GPM *Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. Installation Considerations • For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber. • Please read over these instructions thoroughly before beginning installation. Make sure that you have all tools and supplies needed to complete the installation. • This trim is for use with rough 18113181 (not included). • The water stream from this faucet does not con- tain any air. Hansgrohe recommends the use of an Axor Massaud sink, or of another very deep sink to keep water splashing to a minimum. • Keep this booklet and the receipt (or other proof of date and place of purchase) for this product in a safe place. The receipt is required should it be necessary to request warranty parts. This product is listed by IAPMO and is approved for use in the US and Canada. -
Página 3: Données Techniques
176�F* Capacité nominale 1.1 GPM Caudal máximo 1.1 GPM * Vous devez connaître et respecter tous les codes de plom- *Debe conocer y cumplir todos los códigos locales apli- berie locaux applicables pour le réglage de la température cables para ajustar la temperatura del calentador de agua. du chauffe-eau. À prendre en considération pour Consideraciones para la l’installation instalación • Pour de meilleurs résultats, Hansgrohe recom- • Para obtener mejores resultados, la instalación mande que ce produit soit installé par un plom- debe estar a cargo de un plomero profesional bier professionnel licencié. matriculado. • Veuillez lire attentivement ces instructions avant • Antes de comenzar la instalación, lea estas de procéder à l’installation. Assurez-vous de dis- instrucciones detenidamente. Asegúrese de tener poser de tous les outils et du matériel nécessaires las herramientas y los insumos necesarios para pour l’installation. completar la instalación. • Ce dispositif requiert une pièce intérieure • La unidad requiere una pieza interior de válvula... - Página 4 18112001 Massaud 42300000 8" 25°...
- Página 5 18115001 Massaud 42300000 8" 25°...
- Página 6 English Installation Remove the caps from the plaster shields on the ¹⁄ ₁ ₆" rough valve. Cut the plaster shields so that they extend ¹⁄₁₆" out- side the surface of the finished wall. Seal the wall around the shields using waterproof sealant. Failure to seal the wall may lead to water damage. Remove the plug from the spout outlet using a 17 mm socket wrench. Install the slip couplings on the valves. Cut the slip coupling ³⁄₁₆" from the surface of the finished wall. 17 mm Install the spindle extension. Cut the spindle extension ⁹⁄₁₆" from the surface of the finished wall.
-
Página 7: Instalación
Français Español Installation Instalación Retirez les capuchons. Retire las tapas. Coupez les protecteurs de façon à ce qu’une partie Corte los protectores de yeso de modo que sobresal- de ¹⁄₁₆ po soit à l’extérieur de la surface du mur fini. gan ¹⁄₁₆" de la superficie de la pared terminada. Scellez le mur autour des pro- Selle la pared alrededor del tecteurs à l’aide d’un agent protector de yeso con un sellador d’étanchéité. impermeable. Si le mur n’est pas scellé, l’eau Si no se sella la pared, pueden pourrait éventuellement causer producirse daños por acción del... - Página 8 English Measure from the spout port on the rough to the end of the plaster shield. Record this measurement (X). Add 2" to X. Cut the spout connector so that it is X + 2" long. 2 " Wrap the threads on the spout connector with Teflon thread tape. 12 mm Screw the spout connector into the spout port using a 12 mm Allen wrench. The spout connector should extend 1³⁄₁₆" outside the surface of the finished wall.
- Página 9 Français Español Mesurez la distance entre la surface de la pièce du Mida la distancia desde la superficie de la parte port de bec de remplissage et le rebord extérieur du interna del orificio del surtidor hasta el borde externo protecteur (« X »). del protector de yeso (“X”). Ajoutez 2 po à la mesure « X ». Agregue 2" mm a X. Coupez le raccord fileté de façon à ce qu’il mesure Corte el niple roscado para que tenga X + 2" de « X » + 2 po de long. largo. Enveloppez les filets sur le raccord fileté avec du Envuelva las roscas del niple con cinta de Teflon. ruban Téflon. Instale el niple. Installez le raccord fileté. Apriete el niple con una llave Allen de 12 mm. Serrez le raccord fileté à l’aide d’une clé hexagonale de 12 mm.
- Página 10 English Install the sealing rings, escutcheons, nuts, snap con- nectors and screws, and color rings. Press the handles firmly into place. Install the spout adapter and seal. Install the spout. Tighten the screws using a 3 mm Allen wrench. 3 mm...
- Página 11 Français Español Installez l’écusson, le joint, l’écrou, le connecteur à Instale el escudo, la junta, la tuerca, el conector a encliqueter et vis. presión y el tornillo. Poussez les poignées sur les connecteurs à Coloque las manijas sobre los conectores a presión. encliqueter. Installez l'adapteur du bec et le joint. Instale el adaptador del surtidor y la junta. Installez le bec sur le raccord fileté. Instale el surtidor sobre el niple. Serrez les vis du bec à l’aide d’une clé hexagonale Apriete los tornillos del surtidor con una llave Allen de 3 mm. de 3 mm.
- Página 12 Replacement Parts / Pièces détachées / Repuestos 18112001 97446000 98658000 98465000 98516000 97228000 98134000 18098000 94184000 96392000 98698000 98697000 98677000...
- Página 13 18115001 97448000 98465000 98700000 98516000 97228000 98134000 18098000 94184000 96392000 98697000 98698000 98677000...
- Página 14 User Instructions / Instructions de service / Manejo fermé ouvert cerrado abierto cold froide chaude frío caliente Cleaning / Nettoyage / Limpiar...
- Página 15 • Damage to the product caused by improper care or the use of improper cleaning agents is not covered by the warranty. • If a component of the product is damaged, replace it, as there is risk of injury. Conseil de nettoyage pour les produits Hansgrohe De nos jours le sanitaire moderne, la robinetterie et les douchettes se composent de matériaux très différents pour satisfaire à la demande concernant le design et la fonctionnalité. Pour éviter les détériorations et les réclamations, aussi bien pour l’utilisation que pour le nettoyage prochain, certains critères seront à prendre en considération.
-
Página 16: Indications Importantes
• Les deteriorations imputables à un mauvais entretien ne peuvent être pris en considération par notre garantie. • Par l’action d’un nettoyant sur les revêtements déjà endommagé il se produit une aggravation des dégâts. Recomendación de limpieza para los productos de Hansgrohe Hoy en día, las griferías de baño y de cocina así como duchas modernas se componen de materiales muy distintos para satisfacer las exigencias del mercado respecto al diseño y la funcionalidad. Para evitar daños y reclamaciones hay que tener en cuenta ciertos aspectos tanto en el uso como en su limpieza. Para el cuidado de las griferías y las duchas en principio hay que seguir lo siguiente: • Usar sólo detergentes previstos específicamente para este campo de aplicación. - Página 17 WHAT IS COVERED BY THE WARRANTY The warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship as follows: Hansgrohe will replace at no charge for parts only or, at its option, replace any product or part of the product that proves defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be made in timely fashion, Hansgrohe may elect to refund the purchase price in exchange for the return of the product. LENGTH OF WARRANTY Replacement or repaired parts of products will be covered for the term of this warranty, as stated in the following two sentences. If you are a consumer who purchased the product for use primarily for personal, family or household purposes, this warranty extends for as long as you own the product and the home in which the product is originally installed. If you purchased the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe & Commercial products, and (ii) for 5 years, with respect to Axor products. THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from normal wear and tear, improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration; the use of abrasive or caustic cleaning agents or “no-rinse" cleaning products, or the use of the product in any manner contrary to the product instructions; or conditions in the home such as excessive water pressure or corrosion. C.Labor and other expenses for disconnection, deinstallation, or return of the product for warranty service (including but not limited to proper packaging and shipping costs), or for installation or reinstallation of the product. D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe. E. Any Hansgrohe or Axor product sold for display purposes. F. Rubbed Bronze finish is subject to a 3-year limited warranty. Chrome and all PVD finishes are covered by the limited lifetime warranty. G. Hansgrohe Water Filtration System is subject to a 1-year limited warranty. Warranty does not include replacement filters.
- Página 18 NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OTHER OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT. HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY).
- Página 20 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 800-334-0455 • Fax 770-360-9887 www.hansgrohe-usa.com...