Hansgrohe AXOR Serie Instrucciones De Montaje página 6

1
¹⁄ ₁ ₆"
2
2
3
1
6
3
1
1
2
17 mm
3
2
English
Installation
Remove the caps from the plaster shields on the
rough valve.
Cut the plaster shields so that they extend ¹⁄₁₆" out-
side the surface of the finished wall.
Seal the wall around the shields
using waterproof sealant.
Failure to seal the wall may lead
to water damage.
Remove the plug from the spout outlet using a 17 mm
socket wrench.
Install the slip couplings on the valves.
4
Cut the slip coupling ³⁄₁₆" from the surface of the
finished wall.
Install the spindle extension.
Cut the spindle extension ⁹⁄₁₆" from the surface of the
finished wall.