Functional Description - Black+Decker MATRIX BDCMTRS Manual De Instrucciones

equipment, such as those dust masks that are specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and
other construction activities. Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote
absorption of harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
WARNING:
Do not operate this tool for long periods of time. Vibration caused by the
operating action of this tool may cause permanent injury to fingers, hands, and arms. Use
gloves to provide extra cushion, take frequent rest periods, and limit daily time of use.
SyMBolS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ....direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
............Read instruction manual before use
.................Use proper eye protection
WARNING:
Before attempting any of the following operations, make sure the saw blade has
stopped, and the battery is removed or the cord is unplugged. Used saw blades can be hot.

fUNCTIoNAl DESCRIPTIoN

1. Shoe
2. Blade clamp release lever
3. Secondary Gripping Handle
4. Blade
ASSEMBly
installing and removing a saw blade
WARNING:
To reduce the risk of injury, turn off and remove battery from the tool or
disconnect plug from power source before making any adjustments or removing or installing
attachments or accessories.
blade clamp release lever
WARNING:
Cut hazard. Turn off and remove battery from tool before making any
adjustments or removing or installing attachments or accessories.
WARNING:
Cut hazard. Blade breakage may occur if the blade does not extend past the
shoe and the workpiece during the cut. Increased risk of personal injury, as well as damage to
the shoe and workpiece may result.
SAvE ThESE INSTRUCTIoNS
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
..................earthing terminal
.................safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
..................Use proper respiratory protection
..................Use proper hearing protection
3
3
4
1
3
2