Troubleshooting - Black+Decker MATRIX BDCMTRS Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

• Switch on saw motor before applying pressure.

• Always hold saw firmly with both hands while cutting. whenever possible, the shoe must be

held firmly against the material being cut. This will prevent the saw from jumping or vibrating and

minimize blade breakage.

metal cutting (Figure e)

• Use a finer blade for ferrous metals and a coarse blade for

non-ferrous materials.

• In thin gauge sheet metals it is best to clamp wood to the

underside of the sheet. This will ensure a clean cut without

excess vibration or tearing of metal.

• Avoid forcing cutting blade as this reduces blade life and

causes costly blade breakage.

NOTE:

You should spread a thin film of oil or other coolant

along the line ahead of the saw cut for easier operation and

longer blade life. for cutting aluminum, kerosene is preferred.

pocket cutting - wood only (Figure F)

• Measure the surface area to be cut and mark clearly with a

pencil, chalk, or scriber.

• Insert blade in blade clamp and tighten blade clamp securely.

• place blade at desired cutting point and tip the saw

backward until the back edge of the shoe is resting on the

work surface.

• Switch motor on, permitting blade to attain maximum speed.

• Grip handle steadily and begin a slow, deliberate upward swing

with the handle of the saw, plunging the blade into the wood.

• The blade will begin to feed into material. Always be sure

blade is completely through material before continuing with

pocket cut.

NOTE:

IN AReAS wHeRe BlAde VISIBIlITY IS lIMITed, USe THe edGe Of THe

SHOe AS A GUIde.

pROJECT TIpS

• Cut only with sharp blades; they cut cleaner, faster and put less strain on the motor while cutting.

• when cutting, always ensure that the shoe is resting against the workpiece. This will improve

operator control and minimize vibration.

• for longer blade life, use bi-metal blades. These utilize a carbon steel back welded to high

speed steel teeth making the blade more flexible and less prone to breaking.

Problem

• Unit will not start.

for assistance with your product, visit our website www.blackanddecker.com for the location

of the service center nearest you or call the BlACK+deCKeR help line at 1-800-544-6986.

NoTE: Refer to power Unit instruction manual for troubleshooting solutions regarding operation

of the power Unit.