THE INSTALLATION SPACE
The beverage center and wine chiller can be a free-standing
model or it can be built in using the cut-out dimensions
below.
Locate
Outlet
10-1/2"
9" Max.
34-1/2"-35"
24" Min.
Product dimensions:
Height: 34-1/2" (876 mm)
Width: 23-3/4" (603 mm)
Depth: 25-1/2" (647 mm)
Cut-out dimensions:
Height: 34-1/2–35" (876–889 mm)
Width: 24" (610 mm) minimum
Depth: 24" (610 mm) minimum
The cutout depth should be 24"
The cutout dimensions shown allow for a full door swing and
access to the pull-out racks when installed as a built-in in
standard 24" deep cabinets.
• The door should protrude 2-1/4" beyond the surrounding
cabinets. For easy reference, the back edge of the pocket
handle should protrude a minimum of 5/8" beyond the front
edge of the countertop.
• If installing between frameless cabinets, a 1/2" wide filler
strip or side panel may be needed on hinge side.
The filler strip will act as a spacer between the case and
adjacent cabinet door swing. The width of the opening must
include the filler panels. NOTE: The door should protrude
2-1/4" beyond the surrounding cabinets.
• The beverage center and wine chiller can be installed
freestanding.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded
3-prong electrical receptacle recessed into the back wall as
shown. Electrical must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not recommended.
Installation Instructions
24"
1-1/2"
25-1/2"
34-1/2"
23-3/4"
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacity by installing two beverage centers
or wine chillers together. Or, for a complete refreshment
center, install any two of these units together.
• A side-by-side installation requires at least a 47-1/2" wide
opening. No trim kits required.
• Products must operate from separate, properly grounded
receptacles.
34-1/2"-35"
15"
9
Locate
Outlet
10-1/2"
10-1/2"
24"
14"
9"
9"
1-1/2"
47-1/2" Min.