Optional Accessories - DeWalt DW432 Traducido De Las Instrucciones Originales

Ocultar thumbs Ver también para DW432:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
EN GLI SH
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Make sure all materials to be sanded
are well secured.
• Apply only a gentle pressure to the
workpiece. Excessive pressure does
not improve the sanding effect, but
only results in an increased load on
the machine and causes the abrasive
to tear.
• Avoid overloading.
WARNING: Do not sand magnesium!
Proper Hand Position (fi g. E)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the front
handle (3), with the other hand on the main
handle (23).
Switching On and Off (fi g. A)
Switching on: press the on/off switch (1).
For continuous operation, also press the lock-on
button (2).
Switching off: press the on/off switch again.
Sanding (fi g. A)
• Start with the coarsest grit size.
• Move the tool in long, sweeping strokes.
• Check your work at short intervals.
• Always switch off the tool when work is finished
and before unplugging.
Emptying the Dustbag (fi g. D1, D2)
For efficient dust extraction empty the dustbag when
it is about one third full.
1. Pull the locking collar (16) up.
2. Remove the dustbag (9) and the adaptor (14)
together.
3. Squeeze the marked locations (22) to remove
the adaptor from the dustbag.
4. Gently shake out the dustbag.
26
MAINTENANCE
Your D
WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
WALT, have
E

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dw433

Tabla de contenido