Charging The Battery - Unitech PA690 Guía De Referencia Rápida

Charging the Battery

CAUTION: Turn ON the backup battery switch before charging the battery.
Data you entered may not be properly stored until the built-in
backup battery has been adequately charged.
1. Press and hold the release button on both sides of the USB charging
cable and connect it to the PA690 (1).
2. Plug the AC adapter cable into the power jack of the USB charging cable
(2).
3. Plug the AC adapter cord into an electrical outlet (3).
Using the MicroSD memory card
1. Remove the two screws on the
MicroSD slot shield and remove
the shield.
2. Insert the MicroSD card with the notched corner
as shown.
3. Push the card into the slot until you feel the
MicroSD card click into place.
4. Screw the MicroSD compartment cover back
into place.
Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Unitech electronics co., ltd.
5F., No.135, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231, Taiwan (R.O.C.)
Tel: + 886 2 89121122 Fax: +886 2 89121810 website: www.ute.com