Charging The Battery - Unitech PA600 II Manual Del Usuario

Tabla de contenido

Publicidad

Charging the Battery

Turn the backup battery switch on before charging the battery. Data you
entered may not be properly stored until the built-in backup battery has been
adequately charged.
1
Press and hold the connector button on the USB charging cable and connect it
to the PA600 II (1).
2
Plug the AC adapter cable into the power jack on the USB charging cable (2).
3
Connect the AC adapter into an electrical outlet (3).
1
Using the SD/MMC memory card
1
Remove the four screws from SD compartment cover and remove the cover.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
3
2
2
Insert the SD card with the notched
corner as shown by the icon on the case.

Publicidad

Tabla de contenido
loading

Tabla de contenido