Charging The Battery - Unitech PA600 Guía De Referencia Rápida

Charging the Battery

1
Press and hold the connector button on the USB charging cable and connect it
to the PA600 (1).
2
Plug the AC adapter cable into the power jack on the USB charging cable (2).
3
Connect the AC adapter into an electrical outlet (3).
Caution: When the main battery is removed, the backup battery retains RAM data in
memory for 2 hours, please charge the battery for the period to avoid the data loss in
RAM memory.
Using the SD/MMC memory card
1
Remove the two screws from the SD compartment cover and remove the
cover.
3
Push the card into the slot until you hear an audible system sound; this will sig-
nal that the card is already properly seated within the slot
Copyright 2006 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
2
Insert the SD card with the notched cor-
ner as shown by the icon on the case.