General Maintenance - Ryobi CCG-1801M Manual De Utilización

GB
F D
OPERATION
Hold the gun at a slight angle. If filling a crack, insert
■
the spout into the crack, if possible; otherwise, run the
caulk gun along the surface.
Squeeze the trigger on the caulk gun, allowing the
■
caulk to extrude from the tube tip.
Note: If the bead of caulk is too narrow, re-cut the
nozzle to provide a larger opening. However, it is
better to apply a thin bead of caulk and add a little
more if necessary than to apply too much and attempt
to remove the excess.
Carefully move the caulk gun at an even pace along
■
the gap to be filled as you continue to depress the
switch trigger. Make sure the caulk comes in full
contact with both application surfaces. If necessary,
use your finger to gently press the caulk into a corner
or crack.
Note: The best fill is usually achieved by pushing the
caulk out into the gap in a forward motion. However,
in some cases (particularly where the side materials
are rough or uneven), a pulling motion may work
better as the cartridge will be less likely to get
snagged along the joint.
The motor will shut off automatically when a caulk
■
tube becomes empty. Pull the plunger rod back and
replace the caulk tube as necessary.
To end the caulk bead, release the switch trigger.
■
Draw a moistened finger or other "smoothing
■
tool"along the caulk bead after applying. This will help
the caulk adhere to the application surfaces and will
create a clean, finished appearance.
Use a damp towel or rag to clean off any excess
■
caulk.
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation
or when blowing dust. If operation is dusty,
also wear a dust mask.
E I P NL S DK N FIN GR
English

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
To work properly, the plunger rod of the tool must remain
clean and free of all caulk and adhesive material.
If material does get on the plunger rod mechanism,
clean the material off according to the directions of the
caulk or adhesive manufacturer.
When the tool is shut off by the electronic overload
protection system, always wait for 3 to 5 seconds before
depressing the trigger for restart. Frequently depressing
and releasing the trigger under these circumstances may
cause interior damage to the caulk gun.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
9
RO
H CZ RUS
WARNING
To avoid serious personal injury, always remove
the battery pack from the tool when cleaning or
performing any maintenance.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
HR
PL SLO TR