Important Safety Instructions - HAMPTON BAY 465-919 Manual De Instrucciones

Thank you for purchasing this Hampton Bay interior light fixture. This product has
been manufactured with the highest standards of safety and quality.
FEATURES:
1. Uses 120 volt, 100 Watt MAX, standard (A19), incandescent light bulb (not
included).
2. Can be used with any standard, 120 volt, incandescent style dimmer switch.
3. Designed for mounting to walls.
4. Included swing arm and two-section rotary switch for your lighting necessary.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service Team at
1-877-527-0313 or visit www.homedepot.com. Please reference SKU 465-919, UPC
899089002087.

IMPORTANT SAFETY INSTRUCTIONS

This portable luminaire has a polarized plug (one blade is wider than the other) as a
feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Never use with an extension cord unless plug can be
fully inserted. Do not alter the plug.
1. Read all instructions prior to beginning the installation process.
2. Do not install this lighting system in or near a wet location.
3. CAUTION: HOT SURFACE. Keep away from curtains and other combustible
materials.
4. THE BULB IS HOT! Make sure that the bulb is cool before re-lamping the fixture.
NOTE: All electrical connections must be in accordance with local codes and the
National Electrical Code. If you are unfamiliar with methods of installing electrical
wiring, secure the services of a qualified licensed electrician.
SAVE THESE INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY&INSTALLATION (not included):
Ladder Safety
Goggles
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
(2) Phillips (2) Anchors
Screws
ASSEMBLY INSTRUCTIONS (AS SHOWN IN DIAGRAM):
1. Make sure the main power to the circuit is OFF.
2. Drill holes on the wall, and insert the anchors into the holes.
3. Secure the mounting bracket to anchors by the Phillips screws provided.
4. Insert the thread tube into the bottom box on the canopy and secure it by the nut.
5. Attach the canopy onto the mounting bracket and tighten the decorative nut onto the
canopy mounting screws to secure the fixture.
6. Remove the socket ring (preassembly on the socket) from the lamp socket.
7. Place the fabric shade on to the lamp socket, then replace the socket ring to secure
Gloves Flathead
Screwdriver
Fabric shade
Phillips Electrical
Screwdriver Tape
Socket ring Mounting
strap assembly
2
Wire
Bulb
Cutters
(2) Decorative
nut