Assembling The Stand Mixer - Sunbeam 2377 Manual De Usuario

stand mixer

Assembling the Stand Mixer

Before assembling the mixer, be sure the speed
control dial is in the OFF position and the electric
cord is unplugged.
Attaching the Turntable
Place the revolving turntable into the base of the
stand by pressing the turntable into the center hole
of the adjustment slot until it snaps into place.
Adjusting the Turntable
The turntable must be adjusted depending upon
which bowl size is being used (see "Adding the
Mixing Bowl"). To adjust, press down on the
turntable locator switch and slide switch to the
proper icon.
Attaching and Removing Mixer Head
To attach the mixing head, press in on the mixer-
release trigger, located at the rear of the stand.
Place the mixer head on the stand so that the metal
pivot on the bottom of the mixer head goes into the
latched opening on the top of the stand.
As you release pressure from the mixer-release
trigger, the top of the latch should clamp around the
metal pivot. Once the mixing head is lowered into
position, it will lock into place.
To raise the mixing head, press the head lock button
downward while pulling up on the handle of the
mixing head. Once unlocked, the mixing head can be
removed by pressing the mixer release trigger. Be sure
the mixer head is securely in position before using.
NOTE: This mixer is NOT intended for use away
from the stand.
3