Installation And Connections - GYS SPOT LIFT PRO MOB Manual De Instrucciones

Translation of the original instructions
This manual contains safety and operating instructions. Please read it carefully before using the device for the first
time and keep it in a safe place for future reference.
DESCRIPTION
Thank you for choosing GYS In order to get the maximum profit of your product, please read with care the following
instructions:
The SPOT LIFT PRO MOB is a X shaped lifting tool which is supplied by 2 air bags. This product is for car body garages
to lift the back or the front or the rear of a vehicle. The lifted vehicle may be moved using the lifting tool.
USE
This tool if for vehicle maintenance and must never be used to lift people. The SPOT LIFT PRO MOB must only be used
indoor, sheltered from rain, wind or humidity. The product's weight and the maximal weight of the load to lift are indi-
cated in this manual and the SPOT LIFT PRO's information plate. This tool has not been made for the user to do work
under the vehicle. The lack of consideration for the purpose of use can lead to important risk for the user and this will
be his entire responsibility. The product must be only used for its purpose of use. The user must respect saftey and
prevention standards.
GYS accepts no responsibility regarding damaged causes to people or material due to a misuse of the
SPOT LIFT PRO MOB.

INSTALLATION AND CONNECTIONS

The SPOT LIFT PRO is a jack / lifting tool, so it must be used on a proper surface with good weather conditions. It must
be used on a flat surface which is able to support the vehicle's load. The use and the transport on a rough surface or
similar precluding a good functioning are forbidden.
Operations must be done by expert or responsible operators. Before starting the installation, you must
mark out a clean and free area without any obstacle.
1 - Fixing the handle
2 x M8 x 4T
11
SPOT LIFT PRO MOB SPOT LIFT PRO MOB
2 x M8
2 - Assembling wheel supports
EN EN
11