FAQ & Troubleshooting:
1.
The clock can display in either 12 or 24-hour display format
2.
The (PM) icon will show in the afternoon under the 12-hour display mode
3.
The feeding-days can be changed at any time but the previous schedule will be replaced and will start from the
st
1
new feeding day set
4.
The feeding-times and feeding-volume can be changed at any time and the new settings will be for the rest of
the feeding day/s schedule
5.
Once the schedule has started, the DAYS displayed will be reduced by 1 every day at 0:00 (midnight) until the
end is reached. It will then revert back to the original number of set DAYS and the Feed Alarm will sound. Just
press the START key to start your original program/settings again
6.
If the timer-icon is OFF and all numbers are flashing then no feeding schedule has been set
7.
When the timer icon is ON and all numbers on the LCD display are not flashing then the schedule has started
8.
When the Clock icon is ON the current time is displayed
9.
When the Red (LOW BATT) light FLASHES, the batteries are low and must be replaced
Change all the batteries as soon as possible. You will have to reprogram
the batteries are changed
10. When the LCD display shows (Err), the food delivery door is not closing properly. You need to remove any food
that jams the door.
A.
Switch OFF the Auto Feeder, remove all food, turn your Auto Feeder upside down
B.
Clean both doors hinges with a soft brush
C. After cleaning switch ON the Auto Feeder and refill with food
Note: You will have to reprogram all your original settings before you can use your feeder again
11.Always use the Quick Setup Guide for fast easy programming. If you want more advanced features, use the this
Instruction Manual
11
all your settings again when