[P-Timer] - Christie LX1750 Manual Del Usuario

■ [Filter counter reset] z
Resets the value of [Filter counter].
After replacing the filter, be sure to reset the
counter.
1) Select [Filter counter reset], and press
the <SELECT> button.
z
z A screen for confirming whether to reset is
displayed.
2) Select [Yes], and press the <SELECT>
button.
z
z The confirmation screen is displayed.
3) Select [Yes], and press the <SELECT>
button.
Note
z Reset only after replacing the filter.
z When reset, the display of [Filter warning]
disappears.

[P-timer]

1) Press ▲▼ to select [P-timer].
2) Press the <SELECT> button.
z
z The sub menu 2 is displayed.
3) Press ▲▼ to select an item.
■ [Count up] z
Elapsed time is counted from 00 min 00 sec.
Elapsed time from 00 min 00 sec to 180 min
00 sec is displayed.
■ [Count down] z
Elapsed time is counted down from the set time.
Set the time using [Timer].
■ [Timer] z
Sets the [Count down] time.
1) Select [Timer], and press the
<SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
2) Press ▲▼ to select an item.
Note
z The factory default setting is "10 minutes".
z When [Count up] is selected, this item is grayed out
and cannot be selected.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)
■ [Start] z
Starts the count-up or countdown.
1) Select [Start], and press the <SELECT>
button.
z
z The menu screen is cleared and the timer is
displayed.
■ [Stop] z
Pauses the count-up or countdown.
1) Select [Stop], and press the <SELECT>
button.
z
z The stopped state of the timer is displayed for
approximately three seconds, then the display
returns to the menu screen.
■ [Restart] z
Restarts the count-up or countdown that was
paused using [Stop].
1) Select [Restart], and press the
<SELECT> button.
z
z The menu screen is cleared and the timer is
displayed.
■ [Reset] z
Resets the counted time during operation.
1) Select [Reset], and press the
<SELECT> button.
z
z The count up is returned to "000:00" and the
countdown is returned to the time set on the
timer.
■ [Exit] z
Exits the presentation timer during operation.
1) Select [Exit], and press the <SELECT>
button.
z
z The timer ends, and the screen display returns
to the sub menu.
Note
z You can also use [P-timer] by pressing the
<P-TIMER> button on the remote control.
[Setting] menu
ENGLISH - 73