Using The Appliance - ARIETE Eco Power 2797 Manual De Instrucciones

EN
Small suction device (G)
This can be used to remove dust from books or other delicate items, such as picture frames, etc.
It is suitable for cleaning upholstered furniture, mattresses, cushions, curtains, etc...
This attachment can also be fitted directly to the handle (N).
Narrow suction nozzle with brush (Q)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly
to the handle (N).
VACUMM CLEANER ASSEMBLY
iMPoRtAnt: Before fitting or removing attachments, always make sure that the vacuum
cleaner has been unplugged from the power mains.
- Insert the hose (H) into the air inlet (D) turning it gently until it locks into place (Fig. 2).
- Insert the telescopic tube (P) into the handle (Fig. 3).
- Push the slider device (O) forwards and pull the bottom section of the tube out to the required
length (Fig. 4). To shorten the tube, push it back in the opposite direction.
- Fit the required attachment to the telescopic tube.

USING THE APPLIANCE

CAution: Before using the vacuum cleaner, remove all large or sharp objects from the floor
to avoid any possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord completely and plug the appliance
into the mains socket.
To switch on, press the foot switch (F) on the appliance. The cleaner is equipped with wheels to
move it easily during use.
IMPORTANT: The appliance might make a whistling sound that will stop after a few seconds.
WARninG: Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic
tube become blocked. Remove the cause of the blockage before switching the vacuum
cleaner on again.
WARninG: this appliance is fitted with a safety system that switches it off automatically in
the event of overheating. if this device should be triggered, it will not be possible to switch
on the appliance for about 30 minutes. Wait for the required amount of time before starting
the suction function again and make sure that air can enter the vents and that none of the
filters is clogged.
Secondary air valve (M)
The secondary air valve (M) is on the handle (N) and it serves to regulate suction power. The more
open the valve, the lower the suction power and vice versa.
- Push the valve upwards to open it and downwards to close.
Open the valve to prevent curtains or similar items from being sucked in to the cleaner.
- 9 -