Using The Appliance; Suction Function - ARIETE AQUA force 2481 Manual De Instrucciones

E N
DESCRIPTION OF THE APPLIANCE (Fig. 1)
A Container cover
B Water filter
C Water tank and dust container
D Motor air filter
E Appliance body
F Suction hose attachment
G Suction power adjustment panel
H Foot switch for power cord rewind
I Carry handle
L OnsOff foot switch
M Suction hose

USING THE APPLIANCE

CAUTION: Before using the vacuum cleaner, remove all large or sharp objects from the floor to pres t
vent any damage to the cleaner itself.

Suction function

t Use the relevant lever to remove the cover from the container (A) and pull it upwards (Fig. 2).
s Remove the tank (C), complete with water filter (B), lifting it up by the special handgrip (Fig. 3).
s Remove the water filter (B) (Fig. 4).
s When used as a vacuum cleaner with water filter, the appliance needs a certain amount of water
to start with. Therefore, to use the appliance correctly, it is necessary to pour some water into the
tank (C), through the hole in the top, without exceeding the "MAX" level, which is marked on the
tank.
This allows the air to be filtered and traps any impurities (dust, germs, etc...).
CAUTION: Make sure that the tank is not too full.
NOTE: By adding nontchemical antibacterial products and fresheners, it is possible to purify and
disinfect the air in the room as well as to remove any unpleasant odours.
s Refit the water filter (B) inside the tank (C) and place the assembly inside the body of the appliance
(E) making sure to position the rear tubes from the water filter correctly inside the holes in the aps t
pliance body and on the motor air filter (Fig. 5).
s Refit the cover (A) and press it down gently so that it clicks into place.
s Insert the suction hose (M) into its socket (F) and push it gently until it clicks and is locked into
place.
In the same way, to remove the hose (M), press the release button (Q) and pull the hose out at the
same time (Fig. 6).
CAUTION: Only use the handgrip (I) to lift or carry the appliance. Never transport the appliance while
it is switched on.
t Fit the correct tool for the type of cleaning required and the surface to be cleaned to the attachment
on the handgrip (T) of the suction hose (M).
CAUTION: Before using the appliance, make sure that all filters are correctly fitted and in position
(see "Cleaning and Maintenance").
N Liquid cleaning brush
O Floor brush
P Parquet floor tool
Q Release button
R Suction power adjustment controls
S Battery cover
T Handgrip
U Round brush
V Crevice reach tool
Z Telescopic tube
X Slide device
- 1 -