HOLZMANN MASCHINEN TS315F1600 Instrucciones De Servicio página 42

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
8.2. Edging shoe
 The edging shoe (2) can be moved along
the T-slot (3) on the sliding table and fixed
in the desired position with the screw (4).
 Insert the slot stone into the T-slot (3) and
fix the edging shoe in the desired position
with the screw (4).
8.3. Eccentric wood presser
 The eccentric clamp (5) can also be moved
along the T-slot (3) on the sliding table,
and is used for secure fixing of workpieces.
 Insert the hexagon head screw (slot stone)
into the T-slot (3) on the sliding table.
9. Assembly outrigger table
 Insert the threaded rod (1) into the bore-
hole of the extension of the swivel arm (2).
 Insert the slot stones of the outrigger table
into the T-slot (3) on the sliding table.
 Fix the outrigger table with the two handles
(6) in position on the sliding table.
NOTE: Adjust the height of the outrigger ta-
ble using the locknut system (4). The lock
nuts (5) must also be loosened for this pur-
pose. The outrigger table must be at the
same height as the work table. Check the ad-
justment using a spirit level.
 After the adjustment is completed, fix the
support rod by tightening the 2 lock nuts
(5).
ASSEMBLY
42
TS315F1600