HOLZMANN MASCHINEN TS315F1600 Instrucciones De Servicio página 40

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
6.4. Assembly rip fence
 Loosen the two screws (8) of the rip fence
support.
 Push the slot stones on the rip fence sup-
port into the T-slot of the rip fence (9).
 Retighten the two screws (8).
6.5. Adjustment of the rip fence
The rip fence (8) has to be adjusted so that it
is parallel to the saw blade (7). This can be
achieved by adjusting the rip fence guide:
 Loosen the nuts at the front (10) and the
nuts on the rear (11). Adjust the rip fence
by turning the nuts. This moves the rip
fence either towards or away from the ma-
chine.
 As soon as the rip fence is parallel to the
saw blade, retighten the nuts.
7. Assembly sliding table
 Loosen the middle nut (1) of the two guide
supports that are fixed on both sides of the
machine.
 Insert the slot stones (2) of both guide
supports into the T-slot (3) at the bottom of
the sliding table.
 Retighten the previously loosened middle
nuts (1).
ASSEMBLY
40
TS315F1600