How To Remove The Disc Magazine - Sony DVX-100 Manual De Instrucciones

Preparing the DVD changer
3
Install the disc magazine.
Disc magazine
4
Close the door.
Tip
After you install the disc magazine in the unit, wait until the
unit completes creating the disc list. When the unit completes
the disc list in the magazine:
— the sound of checking discs stops
— the display on the wired remote commander turns off
To start up the DVD changer, proceed with
the operation below.
Press B/X* on the wired remote commander for
start-up.
* You can also press PLAY on the wireless remote
commander for start-up.
The start-up screen appears on the monitor and the unit
starts to play the first disc in the magazine automatically. See
"Playing a disc" (page 16).
B/X
OFF
Caution
If you press B/X on the wired remote commander (or PLAY
on the wireless remote commander) before the unit completes
checking the discs, the disc list is not complete.
14
DISC

How to remove the disc magazine

Press Z.
Note
To prevent injury, withdraw your hand, after you press Z.
The disc magazine is ejected swiftly.
If the disc magazine does not lock properly
Press Z to take out the disc magazine, and reinsert it.
Use the unit with the door closed
Otherwise, foreign objects could enter and contaminate the lenses
inside the unit.
Notes on the disc magazine
• Do not leave the disc magazine in locations subject to high
temperature or high humidity, such as on a car dashboard or in
the rear window where the disc magazine will be exposed to
direct sunlight.
• Do not place more than one disc at a time onto a tray, otherwise
the DVD changer and/or the discs may be damaged.
• Do not drop the disc magazine or otherwise subject it to a
violent shock.
When the tray comes out
Under normal use, the trays should not come out of the
disc magazine. However, if they are pulled out of the disc
magazine, it is easy to re-insert them.
With the cut -away portion of the tray facing you, insert the
right corner of the tray into the slot, then push the left corner
in until it clicks into position.
Note
Do not insert the tray upside down or in the wrong direction.
Z (EJECT)