Message Display - Sony DVX-100 Manual De Instrucciones

Message Display

During operation, the following messages are displayed to help you understand easily.
Message Display on the monitor
"
You can't operate this command now."
"This disc can't be played."
"All discs can't be played."
"Magazine is not loaded."
"Magazine empty"
Message Display on the wired
remote commander
"
E-07"
Cause and/or Corrective Action
•The command you made is not available for the DVD during playback.
, With some DVDs, certain operations are prohibited. It depends on each disc.
•The command you made is not available on the screen currently displayed.
, If you advance to the next step on the screen, the command will become available.
•The region code is neither "the code printed on the back of the unit" nor "ALL."
, Use DVDs with the same region code printed on the back of the unit or "ALL"
(page 5).
•The audio-visual restricted function is activated.
, Change the parental level. See "Parental setup (Changing the parental level)"
(page 44).
•The colour system of the disc is incompatible with the one on your unit.
, Check the colour system of the disc. See "This Unit Can Play the Following Discs"
(page 5) .
•You tried to play a disc that you cannot play on this unit.
, Load a disc that this unit can play.
•You loaded the disc upside down.
, Load the disc properly.
•The disc is dirty.
, Clean the disc.
•Moisture has condensed on the laser lens of this unit.
, Remove the magazine from this unit and wait for about one hour.
•All of the discs in the magazine are those that this unit cannot play.
, Use the discs that this unit can play.
•You didn't insert the magazine.
, Insert the magazine in this unit.
•There were no discs at all in the magazine.
, Insert a disc in the magazine.
Cause and/or Corrective Action
•During playback, the unit does not start to play. Because of scratches, and sticky
residue, etc., the unit cannot read the disc.
, Clean the disc.
, Change the disc.
51