Changing The Transmitting Frequency; How To Change The Transmitting Frequency; Preparing The Dvd Changer; How To Load Discs Into A Magazine - Sony DVX-100 Manual De Instrucciones

Changing the transmitting
frequency
How to change the transmitting
frequency
With this unit, the audio is processed through an FM
tuner for playback. Therefore, signal interference may
occur. In such a case, change the modulated RF signal of
your car stereo as follows.
1
Operate on your car stereo.
1 Turn on your car stereo.
2 Select FM band.
3 Tune the radio to either 88.9 MHz or 88.3 MHz.*
* Tune to the same frequency (88.9 MHz or 88.3 MHz) you
set on the FM modulator of the DVD changer during
installation (Refer to the installation manual supplied with
this unit).
2
Operate on the monitor connected to this DVD
changer.
1 Turn on the monitor.
2 Switch the mode to video.
Note
Read the operation manuals supplied with your car stereo and
monitor.

Preparing the DVD changer

How to load discs into a magazine

With the arrow side facing up
Tray
Tab
x
Labelled side down
There are 10 trays in the magazine:
put only one disc in each tray.
Note
When playing a double-sided disc, put the disc side to be
played up.
How to install the disc magazine to start
up the DVD changer
1
Hold OPEN and unlock.
2
Slide the door toward the right.
Notes
• Open the door fully until you hear the door click.
• To prevent injury, do not insert your hand into the DVD
changer.
continue to next page t
13