Installation Instructions - GE GME04GGHWW Manual Del Propietario E Instrucciones De Instalación

If you have questions, call 1.800.GE.CARES
•
inspector's use.
•
and ordinances.
• Be sure to leave these instructions
with the Consumer.
•
for future reference.
• Do not install the refrigerator where the temperature will go
below 50°F (10°C) because it will not run often enough to
maintain proper temperatures.
• Install it on a floor strong enough to support it fully loaded.
• Do not install it in a recessed area.
• Do not build in the refrigerator.
Allow the following clearances for ease of installation and
proper air circulation.
3 and 4
Cubic Foot Models
1/2" (13 mm)
Sides
Top 2" (51 mm)
Back 2" (51 mm)**
**From the rear cabinet surface to the wall
Save these instructions for local
Observe all governing codes
Keep these instructions
Refrigerator
GEAppliances.com
visit our Website at:
• Remove tape and any labels (except for the rating label)
from your refrigerator. Tape or glue residue can also be
removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm
water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your
refrigerator.
• When moving the refrigerator, do not tilt the refrigerator
beyond 45° from upright position.
at the front corners of the refrigerator
should be set so the refrigerator is firmly positioned
on the floor, and the front is raised just enough that
the door closes easily when opened about halfway.
To adjust the leveling legs, turn the legs counterclockwise to
raise the refrigerator, clockwise to lower it.
Turn counterclockwise to
raise, clockwise to lower.
3 Cubic Foot Models
4 Cubic Foot Models
7