Installation Instructions - GE Profile GSMF2LEB Manual De Uso Y Cuidado

INSTALLATIONS INSTRUCTIONS
Before you begin
Read these instructions completely and carefully.
• IMPORTANT. Save these instructions for local
inspector's use.
• IMPORTANT. Observe all governing codes and
ordinances.
• Note to Installer. Be sure to leave these instructions
with the Consumer.
• Note to Consumer. Keep these instructions for
future reference.
• Skill level. Installation of this appliance requires
basic mechanical skills.
• Completion time. Refrigerator installation 30
minutes. Water line installation 30 minutes.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the warranty.
PREPARATION
Water supply to the ice maker
If the refrigerator has an ice maker, it will have to be
connected to a cold water line.
TOOLS YOU WILL NEED
MOVING THE REFRIGERATOR
1. Loading the refrigerator onto a hand truck.
Leave all tape and door pads on doors until the
refrigerator is in its final location. To move the
refrigerator, use a padded hand truck. Center the
refrigerator on the hand truck and secure the strap
around the refrigerator. DO NOT OVERTIGHTEN THE
STRAP.
2. Remove the base grille.
Remove the grille by removing the two phillips head
screws.
If the refrigerator must go through any
entrance that is less than 38" wide, the doors
must be removed. Proceed to Step 3.
If all entrances are more than 38" wide, skip
this section.
3. Disconnect the water coupling (on some models)
If the refrigerator has a water dispenser, there is a
water line from the cabinet into the bottom hinge on the
freezer door that must be disconnected. To disconnect,
push in on the white collar of the coupling and pull out
the tubing.
45