How To Operate - Nostalgia Products HomeCraft HCPO12BK Manual De Instrucciones

HOW TO OPERATE

Before you begin, wipe the outer housing and inner cavity wall with a damp cloth.
Clean the Wire Rack in hot, sudsy water. It is also recommended to heat up the pizza
oven empty for approximately 10 minutes. This will burn off brand new scent. A
little smoke may occur however, but this is normal and will disappear shortly.
Place the 12-INCH CONVECTION PIZZA OVEN WITH STONE on a stable surface
near an electrical outlet before starting. Make sure that the cord is away from
any water source, then plug the appliance into an electrical outlet.
1. Open the oven door and place a pizza on the Wire Rack, then close the oven door.
Pizza should be evenly spaced on the Wire Rack so that it toasts evenly.
NOTE: When using the stone, preheat oven for at least 10 minutes or longer
at 450 degrees so the stone is hot when inserting the pizza.
2. Rotate the Temperature Gauge clockwise to desired temperature.
3. After setting the timer, the power indicator light will illuminate.
NOTE: Rotate pizzas 180° half way through the cycle for even cooking.
4. When the timer has expired, the timer bell will ring and the dial will
be back to the "0"position. To stop the cycle at any time, simply turn
the Timer to the "0" position and the timer bell will ring.
5. Using a hot pad or oven mitt, carefully remove your pizza from the oven.
7