Kohler K-T945 Guia De Instalacion página 3

Faucet
Outlet
Port
Flange
Spout
Shank
Escutcheon
1. Install the Spout
IMPORTANT! Use care when installing the spout to avoid
scratching the finish.
IMPORTANT! Ensure the setscrew is backed out of the spout or
removed to prevent damage to the spout shank when installing the
spout to the faucet outlet port.
Using the provided hex wrench, unthread the setscrew out of the
spout until it does not protrude inside the spout.
Insert the inlet end of the spout shank into the faucet outlet port.
Secure the spout assembly using the three provided screws.
Confirm that the O-ring is in the notch on the interior of the
spout escutcheon. Apply plumbers putty or other sealant to the
back surface of the spout escutcheon according to the putty
manufacturer's instructions.
Carefully slide the escutcheon over the spout and install the
spout over the spout shank.
Tighten the setscrew to secure the spout in place.
Press the escutcheon firmly against the finished wall.
Remove any excess putty or sealant.
Kohler Co.
Apply plumbers
putty.
Screws
O-Ring
Setscrew
3
Spout
1023410-2-B