Publicidad
4
Install rose
Align dimple
and groove.
5
Install lever
Lever catch
6
Install strike
7
Check lock function
Customer Service
1-877-671-7011
Rotate rose
until it stops.
Rotate lever slightly
toward lever catch and
firmly push on until lever
catch engages.
www.allegion.com/us
Door Thickness Adjustment
For 1C\v" thick doors, NO ADJUSTMENT IS REQUIRED.
•
•
For 1C\," thick doors, install the Optional Spacers (see steps
2 and 3). No further adjustment is required.
•
For 1B\,", 2" or 2Z\," doors, complete the following steps.
1. Remove adjustment plate and door thickness insert.
2. Reinsert door thickness insert with correct dimension visible.
1B\,"
2"
2Z\,"
If door thickness insert is missing, use marks on chassis:
1C\," Align adjustment plate with 1C\v" mark.
Use optional spacers. (For ND85 rotate additional half turn CCW.)
1B\," Tighten adjustment plate to bottom, then rotate a half turn
CCW.
1C\v" Align adjustment plate with 1C\v" mark. (For ND85 rotate an
additional half turn CCW.)
2" Align adjustment plate with 2" mark.
2Z\," Align adjustment plate with 2" mark, then rotate an additional
full turn CCW.
CCW = counterclockwise
3. Reinstall adjustment plate.
Tighten until plate contacts door thickness insert flat.
Door thickness
insert
2" 1C\v"
© Allegion 2014
Printed in U.S.A.
P515-168 Rev. 01/14-d
Publicidad
