Accessing The Web Configurator - Zyxel P-335 Plus Guia De Inicio Rapido

The PR Switch
The P-335 Plus can work as a router with print server or a print server only. To configure the P-335 Plus's
operating mode, push the PR switch on the rear panel to either the P (Print server) or the R (Router) side.
Note: The connection wizard is available only when the P-335 Plus is in router mode.
The P-335 Plus in print server mode does not support DHCP server. To access the web
configurator, make sure your computer's IP address is in the same subnet as the P-335 Plus.
When the P-335 Plus is in print server mode, all LAN and WAN ports act as a hub.

2 Accessing the Web Configurator

1 Make sure the PR switch on the rear panel is set to the R (Router) side.
2 Launch your web browser. Enter "192.168.1.1" as the web site address.
Note: If the login screen does not display, check your browser's security settings (see
Troubleshooting for details) or make sure your computer is set to receive an IP address
dynamically (see
3 The Password window displays. Enter the
password ("1234" is the default) and click Login.
4 Change the password in the screen that follows
and click Apply.
Set Up Your Computer's IP
ENGLISH
Address).
5 Click Go to Wizard setup to set up your P-335 Plus
for the first time.
5