Krups BW3140 Manual Del Usuario página 3

„ „
Kettle is only to be used with the base provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (fig 4)
„ „
Never fill the kettle when it is on its base.
„ „
Do not fill it above the maximum level, or below the minimum level. If the kettle is too
full, boiling water may spill out.
„ „
Do not use without water.
„ „
Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET.
5. TO START THE KETTLE
„ „
Press the on/off button on the base).
„ „
The temperature of the water in the kettle is displayed on the screen.
TO BOIL THE WATER
2 options:
–
„
If you would like to boil the kettle, press the
–
„
If you would like to choose your own temperature (7 options: 100° - 95° - 90° -
85° - 80° - 70° - 60°), press the
„ „
Once the temperature has been chosen (either with the
boiling cycle will begin automatically after 2 seconds, and will stop once the selected
temperature has been reached (accurate to +/- 3°C).
„ „
To stop the cycle once it is under way, press the selected button once again (either
the or
KEEP WARM FUNCTION
„ „
Your kettle has a 'keep warm' function
beforehand, the water will be heated to this temperature and then kept at this
temperature for 1 hour; if not then it will be kept warm at 60°C.
„ „
The maximum permitted temperature for the Keep Warm function is 95°C.
NOTE
„ „
The screen will turn off automatically after 30 minutes (standby mode) but all the
buttons will remain active. This means that pressing any button will switch the screen
back on.
„ „
If you use the
the kettle, the function will not be activated and the cycle will not start.
Example: if the water is 90°C, you will not be able to start cycles for temperatures of
60°C/70°C/80°C/85°C.
„ „
Recommended temperatures :
–
„
70°C : white tea/green tea
–
„
90°C : black tea
–
„
100°C : boiling water/infusions
6. THE KETTLE WILL SWITCH OFF AUTOMATICALLY
„ „
As soon as the water reaches boiling point or the chosen temperature.
„ „
Do not leave water in the kettle after use as this quickens the formation of scale.
2
button).
button to select a temperature less than that of the water already in
button.
button until you reach the desired temperature.
. If you have selected a temperature
or button) the