Publicidad
Idiomas disponibles
Idiomas disponibles
6. CONTROLS
The controls of the appliance are situated at the front inside a protected recess.
switch:
to turn on the refrigeration system.
6. Thermometer:
to read the temperature in the counter.
appliance.
A)
Press key
3 "SET or P"
by pressing key
or
4 "UP"
thermostat, located on the side panel, immediately above the shelf (Model 3TV).
bottom section, for white wines (thermostat on the outside of the panel). +9°C in the middle section, for
rosé wines (thermostat inside cabinet, in centre section). +18°C in top section, for red wines to drink at
cellar temperature (internal thermostat in top section)
7. CHECKING CORRECT OPERATION BEFORE USE
Make sure that: 1.
the plug is connected; . the refrigeration unit switch is turned on (green light lit up);
3
. thermometer shows the desired temperature for the goods to be stored; . lights are turned on;
is firmly closed;
6.
appliance is not exposed to direct sunlight or to powerful lamps; . ambient
temperature does not exceed +30°C with 55% R.H. (climatic class 4); . there is sufficient ventilation for
the motor compartment; there is a clearance of at least 30 cm in front of the grill; . the cabinet is suitably
filled and shelves are not overloaded (max. 90 kg per shelf, equal to approximately 60 bottles).
8. REPLACEMENT OF INTERNAL LIGHT BULBS
1.
Switch off the appliance.
fluorescent tube with its protective cover from the top lamp socket.
lamp socket. . Remove the protective cover. . Replace the fluorescent tube. . Reassemble by
5
following the above instructions in reverse order (see fig. 5).
9. REPLACING A SLIDING GLASS DOOR
1.
Open the sliding doors.
3.
Lift the door, freeing the bottom part from the lower track.
from the top track.
5.
If the internal door needs replacing, first remove the external one and then remove
the internal one in the same way.
corners, then remove one side of the perimetral frame and slide out the door.
figure 6)
10. REPLACING A FIXED GLASS PANEL
1.
Switch off the appliance.
from the upper corner mountings at the door jamb and neon lamp.
and remove.
5.
Slide out the glass panel by pulling it upwards.
(see figure 7).
Operator's guide
2. Light switch:
once to display the temperature set-point, which can be changed
. To adjust temperature of internal shelves, turn the relevant
5 "DOWN"
2
2.
Undo the screws which hold the top lamp socket in place. . Detach the
6
2.
Use a hook to extract the locking profile from the edge of the outer door.
6.
Using a hexagonal wrench, unscrew the Allen screws from the two
2.
Remove the two doors.
7
to turn on the light inside the display cabinet.
Thermostat:
to adjust the temperature in the
(see fig. 4).
4
8
4.
Take the tube out of the bottom
7
4.
Pull outwards and lower the door to free it
7.
3.
Unscrew both the internal and external screws
4.
Slide the corner mountings upwards
6.
Replace with a new glass panel
1. Refrigeration
Suggestions: +6°C in
5.
door
7
9
3
Replace the door (see
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Publicidad
