BGS technic 405 Manual De Instrucciones página 2

Instruction for rivets
1. Drill a hole in the workplace first.
2. Select the appropriate nose piece for the
chosen rivet.
3. Release and open the handles.
4. Put the rivet into the nose piece of the riveter
and set it into the hole of the workpiece.
5. Tighten the handles. The rivet should be cut in
1 or 2 operations.
6. Release the handles and remove the mandrel
from the nose piece after completing work.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Professional Riveter Set
pull bar
jaw case
front sleeve
nose piece
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
pull bar
Instruction for nuts
1. Drill a hole in workpiece first.
2. Replace the mandrel.
3. Release the handle. Fix the mandrel with
spanner and fasten the fixing screw.
4. Fasten the nut to the mandrel and set into hole
of the workplace.
5. Tighten the handle, if the nut is not tight
enough with the workplace, just release the
handle to fasten the pull bar, then tighten the
handle again.
6. Release the handle and pull bar to make the
nut and mandrel separate. And the nut will be
inserted in the workplace.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Art. 405
front sleeve
mandrel
nose piece