Technical Data - Skil 1930 Manual Original

a
Laser measure
INTRODUCTION
• This tool is intended for measuring
distances indoors as well as outdoors
by means of laser beam projection
• When used properly, this tool easily
and accurately measures length,
surface and angles
• The measuring tool is suitable
exclusively for operation in enclosed
working sites
• This tool is not intended for
professional use
• Save these instructions for future
reference and include them with
the measuring tool when giving it
to a third party

TECHNICAL DATA

Distance measuring
range*
Distance measuring
accuracy*
Smallest measuring unit 0.001m
Measuring time
Angle measurement
range
Angle measurement
accuracy
Operating temperature
Storage temperature
Relative humidity (max.) 90%
Laser class
Laser type
Battery
Operating time
Weight
Dimensions (length x
width x height)
1930
0.3 - 30m
± 3mm
0.7 sec
±90°
±0.5°
0°C to 40°C
-20°C to +70°C
2
635nm, <1 mW
Li-Polymer,
3.7V, 500mAh
up to 3000
measurements
0.13 kg
128 x 58 x 25
mm
6
Automatic switch-off
laser
measuring tool
* Important: under unfavourable
conditions (e.g. in bright light, or poor
reflection) the tool's measuring range and
accuracy will be reduced
TOOL ELEMENTS 1
A Exit opening for laser beam
B Reception lens
C Display
D Up button
E Down button
F Angle measurement base
G Main button
H Charger cable
J Charger interface
SAFETY
• All instructions must be read and
observed in order to work safely
with the measuring tool 2
• If the equipment is used in a manner
not specified by the manufacturer, the
protection provided by the equipment
may be impaired
• Never make warning signs on the
measuring tool unrecognisable
• -The use of other operating
or adjusting equipment or the
application of other processing
methods than those mentioned
here can lead to dangerous
radiation exposure
• Do not direct the laser beam at
persons or animals and do not
stare into the direct or reflected
laser beam yourself, not even
from a distance (you could blind
somebody, cause accidents or
damage your eyes) 4
• If laser radiation strikes your eye,
you must deliberately close your
after approx.
20 sec. of non-
measurement
after approx. 3
min. of inactivity
(approx. 6
min. In digital
levelling mode)