LaserLiner Quadrum OneTouch Manual Del Usuario página 19

Quadrum OneTouch / Quadrum OneTouch Green
Horizontal levelling
– Horizontal: Position the device on a level surface or
on a tripod.
– Press the "ON/OFF" switch
!
auto/man function LED OFF: Automatic alignment
– The device levels itself automatically to within a range of ±5°. The laser
rotates and the tilt, X and Y LEDs flash during the set-up phase. When
levelling is complete, the tilt LED flashes rapidly and the X and Y LEDs are
permanently on. The laser rotates at maximum speed. Refer also to the
sections about "Sensor Automatic" and "ADS Tilt".
If the device has been placed on a surface with too much of a slope
!
(more than 5°), the prism head remains stationary and the laser starts
to flash. The device must then be placed on a more even surface.
Slope function up to 5° – horizontal
This function deactivates the automatic sensor. To use the function, press the
auto/man button. The plus/minus buttons are used to re-adjust the slope by
means of a motor. In the process the X-and Y-axis can be adjust separately.
Refer to the illustrations below.
man
auto
± 5°
X Y
19
GB