Adjustment Mode - LaserLiner Quadrum OneTouch Manual Del Usuario

Quadrum OneTouch / Quadrum OneTouch Green

Adjustment mode

Take the alignment of the rotary laser into account when
performing adjustment work. Always adjust all the axes.
X axis adjustment
Activate adjustment mode: Switch on the Quadrum OneTouch.
Simultaneously press the auto/man button and the X/Y button
until the X LED flashes rapidly.
Adjustment: Use the plus/minus buttons to move the laser
from its current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Simultaneously press the auto/man button and the
X/Y button until the X LED lights up.
Y axis adjustment
Activate adjustment mode: Switch on the Quadrum OneTouch.
Simultaneously press the auto/man button and the X/Y button
until the X LED flashes rapidly.
Switch to the Y axis using the X/Y button.
Adjustment: Use the plus/minus buttons to move the laser
from its current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Simultaneously press the auto/man button and the
X/Y button until the Y LED lights up.
Regularly check the adjustment
!
before use, after transport and after
extended periods of storage. Always
make sure to control all axes.
X- / Y-
Axis
Y
X
23
GB