Yakima HullRaiser Manual De Instrucciones página 2

do you have - square - round - or FaCTory Crossbars?
square
ATTACH 2 SNAPAROUNDS
Attach SnapArounds or
MightyMounts in the same
direction on each bar.
FaCTory
Crossbars
If your MightyMounts require bar
caps, install them now.
MightyMounts must use kit #8860007
available from your YAKIMA dealer.
FaCTory
Crossbars
and
square Remove one
base top and
bottom.
round
bars
(sTarT
here)
PLACE PADS ONTO BASES.
1033397A-2/12
Loosen the
tabs in the
SnapArounds by
bending them
repeatedly.
ONTO EACH BAR...
Choose Carrier
posiTion on vehiCle.
Large round holes in bases must
face the rear of the vehicle.
Attach two SnapArounds in
opposite directions on each bar.
Remove the
tabs with
scissors or
pliers.
universal
MighTyMounTs
(#03590)
Follow the Universal
MightyMount instructions
and refer to this instruction
for correct installation.
• Reinstall bases with
square holes and round
holes aligned.
• TIGHTEN completely.
• Continue to step 3.
ATTACH PADS TO
BASES WITH PLUGS.
...contInUe to steP 2
(FoR sqUaRe baRs).
Plugs can be used only
once. If you reconfigure
the bases, see your Yakima
Dealer for replacement
plugs #8890058.