Optional Accessories; Maintenance - Nice TTN3724HS Instrucciones Y Advertencias Para La Instalación Y El Uso

6

OPTIONAL ACCESSORIES

The following optional accessories are available:
ACCESSORIES
PLA10
PLA11
PS324
Refer to the user manuals of the various individual products.
7

MAINTENANCE

To ensure that the level of safety of the installation is maintained and that the system remains reliable and operational, it must be serviced regularly
in observance of the safety regulations given in this manual and established legislation.
The gearmotor must be serviced no later than 6 months after commissioning.
01. Disconnect all power supplies
02.
Check for any deterioration in automation system components, paying special attention to erosion or oxidation of its structural parts.
Replace any parts which are below the required standard.
03.
Check that all screw fasteners are fully tightened down
04. Check the wear of all moving parts and replace any worn components
05. Connect the power supplies up again, and run all the tests and checks described in Chapter 4
For the other equipment in the system, refer to its user manuals.
and declaration of incorporation of "partly completed machinery"
Revision: 3 - Language: EN - Name of manufacturer: NICE S.p.A. - Address: Via Callalta n°1, 31046 Oderzo (TV) Italy - Person au-
thorised to draw up the technical documentation: NICE S.p.A. - Type of product: Electromechanical gearmotor - Model/Type: TTN
3724HSC,TTN3724HS,TTN3724RHS, TTN6024HS, TTN6024RHS - Accessories: Refer to the catalog.
The undersigned, Roberto Griffa, in the role of Chief Executive Officer, declares under his sole responsibility, that the product specified above
conforms to the provisions of the following directives:
• Directive 2014/30/EU (EMC): EN 61000-6-2:2019 - EN 61000-6-3:2007+A1:2011
• Directive 2011/65/UE (RoHS II)
The product also complies with the following directives according to the requirements envisaged for "partly completed machinery" (Annex
II, part 1, section B):
• Directive 2006/42/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 17 May 2006 related to machinery, and which amends the directive
95/16/EC (recast).
- It is hereby declared that the pertinent technical documentation has been compiled in compliance with appendix VII B of directive 2006/42/
EC and that the following essential requirements have been observed: 1.1.1- 1.1.2- 1.1.3- 1.2.1-1.2.6- 1.5.1-1.5.2- 1.5.5- 1.5.6- 1.5.7-
1.5.8- 1.5.10- 1.5.11
- The manufacturer undertakes to transmit to the national authorities, in response to a motivated request, all information regarding the "partly
completed machinery", while maintaining full rights to the related intellectual property.
- Should the "partly completed machinery" be put into service in a European country with an official language other than that used in this
declaration, the importer is obliged to arrange for the relative translation to accompany this declaration.
- The "partly completed machinery" must not be used until the final machine in which it is incorporated is in turn declared as compliant, if ap-
plicable, with the provisions of directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014 + A13:2017 + A1:2019 + A2:2019 +A14:2019
EN 62233:2008
EN 60335-2-103:2015
Place and Date:
Oderzo, 09/11/2020
EU Declaration of Conformity (N. 605/TITAN)
Ing. Roberto Griffa
(Chief Executive Officer)
English – 11