Publicidad
Idiomas disponibles
Idiomas disponibles
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
RELEASE SYSTEM
o release procede as follows:
T
- Insert the key, push and turn about 90° clockwise (Fig. 1).
- Pull the release lever until it stops, about 90° (Fig. 2).
Note: when pulling the release lever the electronic control unit receives a stop impulse through the micro-switch
placed on the inside (if present).
To relock procede as follows:
- Push the release lever to complete closing.
- Rotate the key counter-clockwise and extract it.
Once the lock has been restored the electronic control unit is reactivated (only if a micro-switch is mounted) .
Close
Operator locked
Fig. 1
RELEASE SYSTEM (OPTIONAL)
To release operate as follows:
- Take off the protection cap of the lock.
- Insert the key and turn about 90° into clockwise direction (Fig. 3).
- Pull the door until its complete opening (Fig. 4).
- Open manually the leaf
To block again operate as follows:
- Close the door again.
- Turn the key about 90° into anti-clockwise direction.
- Extract the key.
- Close the lock again with the protection cap.
Fig. 3
2
67411060
®
FLIPPER
FITTING AND CONNECTION INSTRUCTIONS
To the attention of users and technicians
Open
Push and
turn
90°
Operator locked
Fig. 2
Fig. 4
ENGLISH
Operator released
Operator released
Publicidad
