Angle Adjustment - Rollei City Traveler Mini Instrucciones

Instruction Manual Rollei City Traveler Mini
4
Tripod
Thank you for choosing this Rollei product. Please read the
manual carefully before you use this travel tripod.
The tripods of the City Traveler Series are made out of Carbon.
Therefore they are leightweight and due to there compact
design, these tripods are ideal for using them on your next
city trip. City Traveler tripods are especially designed for DSLM
cameras (mirrorless cameras) and support them excellently.
Tripod Parts
1
Quick release plate
2 Ball head locking knob
3
Anti-rotate screw
4
Leg angle adjustment
5
Platform locking knob
6
Base locking knob
7
Center column lock
8
Center column
9
Rubber feet
10

Angle Adjustment

To change the leg angle press the angle adjustment knob
down. Then you are able to change the leg's position. There
are three lock-in position on the leg angle adjustment. If
you have put the leg up and then lower it down the leg
angle adjustment know will automatically go into the
lock-in positions. To put the tripod into the folded length,
you need to put the leg to the top by folding it by 180°.
Therefore press the leg angle adjustment knob down and
while you have pressed it push the leg to the top.
11
180° reverse folding
12
Center Column
To adjust the height of the center column loosen the center
column lock by turning it counter clockwise, move the cen-
ter column up or down to your desired height. Finally lock
the center column position by turning the center column
lock clockwise.
To be able to put the tripod to its lowest position you can
separate the center column by unscrewing the lowest part
of it. Then only insert the top part. Furthermore you can
also insert the center column the other way round.
13
Anti-rotate screw
If you have attached a ball head on the tripod you can
firmly fix it by using the anti-rotate screw. With this
function the ball head cannot screw of by accident. Use
the wrench to screw the anti-rotate screw inside the plate.
Please make sure that the ball head is fixed, but that the
panoramic function can still be used. If the anti-rotate screw
is too tight, the panorama function of the ball head might
be blocked. If this is the case please unscrew the anti-rotate
screw a bit, until the panorama function is working well
again.
ENGLISH
1
2
3
4
10
12
Tighten
14 Leg length adjustment
To adjust the leg length rotate clockwise the rubber feet
totally. Then you can pull out the leg completely. Finally
please lock the leg length by rotating it counter clockwise.
Please note the leg length can be locked at any position.
Attention
1. Do not overload the tripod.
2. Always tighten the center column lock if you use the tripod.
3. For your safety do not let the product touch any electric
objects, high voltage equipment and superactive chemicals.
4. Only use standard lubricant when necessary.
Cleaning
After using the tripod in water, sand or dust, please clean it
carefully. Therefore expand all legs and use a dry cloth to clean
the tripod. If it is completely wet, let it dry completely. If you
have used it in salt water or sand you should also clean and
rinse it with fresh water.
4 22–13 mm 19 cm
5
6
7
8
14
9
11
Loosen
46 cm 42 cm 419 g
13
5 kg