Power Supply - THOMSON RCD150 Manual De Instrucciones

This appliance can operate on batteries or on mains power
supply.
Verify that the appliance is switched off.
Connect the power cable to the AC socket on the back and
then plug the other end to the wall socket.
not feed the appliance.
It is preferable to remove the batteries if the cable is connected
to the power supply in order to avoid their being damaged.
PORTABLE CD RADIO
RCD150 / RCD151 / RCD152
Lift the cover of the battery compartment on the back of the
Insert 8 LR14 (C) 1.5V batteries (not supplied) taking care to
observe the indicated polarity.
Close the cover of the battery compartment.
Note: The power cable must be disconnected from the socket
on the back of the appliance or from the wall socket in order for
the appliance to be fed by the batteries.
2

POWER SUPPLY

19
11 EN