Sauder 425018 Instrucciones De Montaje página 16

Step 12
Before fastening a DOOR to your unit, be sure the mounting screw is against the
å
stops as shown in the right diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (J) to the RIGHT END (A2) as shown in the lower diagram.
å
Use the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them. Repeat fastening the SMALL DOOR (K) to the
LEFT END (B2).
Fasten two KNOBS (155K) to the DOORS (J and K). Use two BLACK 1-1/8" PAN
å
HEAD SCREWS (9S).
Push two DOOR STOPS (4I) into the holes in the TOP (M2) and SMALL FIXED
å
SHELF (D) as shown.
4I
9S
BLACK 1-1/8" PAN HEAD SCREW
(2 used for the KNOBS)
Page 16
B2
155K
K
M2
D
Stop
Mounting
screw
Hinge
A2
155K
J