Tabla de contenido
Publicidad
Bracket Assembly And Cable Clip
Single And Dual Monitor Applications
1
With the Lever (A) open, position the Dual Bracket (B)
at the desired height on the Post (C).
2
Close the Lever entirely.
3
If you are adding a second monitor, lift and remove the Cover (D).
①
B
C
Triple Monitor Applications
1
Remove the two set screws (E) that retain the Bracket
Cap (F). Lift Bracket Cap upwards to remove it.
2
Install the Extension Bracket (G) on top of the Dual
Bracket. Insert Tabs (H) into the Pockets (J). Replace the
Set Screws. Tighten screws until the Extension Bracket is
secure and the screws are flush with the surface.
3
Insert the Bracket Cap into the top of the Extension
Bracket. Press down until it clicks into place.
Cable Routing Hook
1
Spread the hooks around the post in the desired location.
2
Squeeze the two sides until the Lock (K) snaps together.
3
To release, use fingernail to disengage the Lock.
②
A
③
D
④
F
⑤
F
H
⑥
K
E
G
J
5
Publicidad
Tabla de contenido
