Sauder 414819 Manual De Instrucciones página 12

Step 8
Carefully turn your unit over onto its front edges. Lay the UPPER BACK (D) over the upper opening of your cabinet.
å
Make equal margins along the top and side edges of the BACK (D). Push on opposite corners of your unit if needed to make it "square".
å
Fasten the UPPER BACK (D) to your unit using the NAILS (6).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (E).
å
Lay the LOWER BACK (I) over the lower opening of your cabinet. The tabs in the LOWER BACK should fi t in between
å
the tabs of the UPPER BACK (D).
Make equal margins along the bottom and side edges of theLOWER BACK (I). Push on opposite corners of your unit if
å
needed to make it "square".
Fasten the LOWER BACK (I) to your unit using the remaining NAILS (6).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (E).
å
Tap four TACK GLIDES (5) into the LOWER ENDS (H and J) and LEGS (M and N) as shown.
å
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Page 12
This hole should be left empty
for the SAFETY STRAP.
D
E
www.sauder.com
(41 used in this step)
I
J
N
6
NAIL
H
M
5
414819