HJM 310 Instrucciones De Uso página 14

Radiador Halógeno_Maquetación 1 25/06/16 16:40 Página 14
ASSEMBLY
Follow instructions for assembly. Remove butterfly nuts form the
base.
1) Pull the power cord through the base plate and place the cord
through the cable channel to ensure that it is secure.
2) Ensure that the base plate is firmly in position and then gently
screw the butterfly nuts into position and secure firmly.
OPERATION
1) Insert plug into socket
2) Set the power supply switch (orange colour) to the "ON" position.
This will enable the upper and middle heating tube to start. To con-
trol the other tubes use switches 2 and 3.
3) To allow the heater to oscillate please press the 'TURN' button.
WARNING
- Do not use in a wet area.
- Do no immerse in water.
- Do not cover or place to close to furniture or clothing.
- Always consult a qualified electrician.
- This unit must be only be used indoor's.
- This unit must only be used under supervision.
- Not be used in bathrooms.
- Do not use this product with a programmable timer.
- A slight burning smell and a little smoke may occur when the hea-
ter is used for the first time ONLY. SHOULD THIS BE A RECU-
RRING PROBLEM, PLEASE RETURN THE HEATER TO THE
RETAILER.
- Do NOT locate this unit immediately below a socket outlet.
- If the supply cord is damaged, it must be replaced by the manufac-
turer its service agent or a similarly qualified person in order to
avoid a hazard.
- 14 -
E
N
G
L
I
S
H